$649.00
Information: RPM Range: 1700-4500 Drops EGT 200-300 Increased Mid Range power Duration at .050″ of lift 188 Intake, 220 Exhaust We only offer warranty on our cams if our lifters...
Availability: In Stock
Sku: 07-c-188/220
Vendor: Hamilton Cams

Information:

  • RPM Range: 1700-4500
  • Drops EGT 200-300
  • Increased Mid Range power
  • Duration at .050″ of lift 188 Intake, 220 Exhaust
  • We only offer warranty on our cams if our lifters and springs are used.

Modification Required:

  • For it to be “drop in” on a 12v you will need no more than .018″ piston protrusion and at least .055″ valve face depth with a standard head gasket and a 99 intake centerline. On a 24v you will need no more than .018″ piston protrusion and at least .038″ valve face depth with a standard gasket. If you do not meet the minimum requirements for piston to valve clearance, don’t worry, you can still run an oversize head gasket or cut valve reliefs.
  • Although this is considered a drop in cam it is important to check clearances
  • For the Steel version you will need at least two bushings installed in the cam tunnel, otherwise the steel could eat into the cast iron block
  • We always recommend new lifters when changing a cam.

Applications:

  • Drag strip
  • Stock class pulling

Break in:

To make sure that you have no issues during break-in, follow these few suggestions.
  • Make sure that the cam has a Liberal amount of quality assembly lube applied
  • DO NOT let the engine start without oil pressure
  • When this is a new engine, be sure to put a liberal amount of assembly lube in the oil pump and prime the oil filter
  • Be sure to change the oil after you have done your break-in procedure. When the filter and oil system are already primed, engine will get oil pressure much faster than if the oil is changed at the same time.
  • Disconnect the fuel system and spin the engine with the starter until oil pressure can be read or until oil is coming out of the rocker arms.
  • Once oil pressure has been verified, let the engine start and run until up to operating temp
  • Adjust valves then you are cleared to abuse your engine. Enjoy the added airflow
  • if you need to re-torque or “hot-torque “the head, do so before adjusting valves. When you retorque the head, the valve lash setting, so it is important to set lash last.